Applications
Accelerate the plaster plate installation process

The process of installing a plasterboard usually consists of two steps: placement and pasting. These steps are usually performed with the help of a mortar or gripping paste and joint paste. Quilosa has developed an adhesive foam that allows you to save a lot of time compared to the traditional method of installation: our new product Adhesive Foam Fixation Boards.
The process of installing a plasterboard usually consists of two steps: placement and pasting. These steps are usually performed with the help of a mortar or gripping paste and joint paste. Quilosa has developed an adhesive foam that allows you to save a lot of time compared to the traditional method of installation: our new product
PREVIOUS CONSIDERATIONS:
1. Before you start, place a piece as a wedge at the bottom of the wall. Make sure surfaces are dust free.
2. Shake the canister of foam adhesive strongly for about 30 seconds. Screw the application gun into the valve. The product will be ready for use.
APPLICATION INSTRUCTIONS:
1. Apply an adhesive cord 2-3 cm around the perimeter of the board and about 4 cm from tje edge to prevent the adhesive from overflowing when joining the surfaces. Apply by zigzag starting from the corner of the board.
2. Once the adhesive has been applied, put the plate on the wall and press carefully so as not to crush the cord.
3. The Adhesive Foam Fixation Boards is able to cover unevenness in the wall of up to 2 cm.
4. After 3 minutes, set the final position of the board
5. The adhesion will be sufficient after 30 minutes to start filling the points.
6. When finished, clean your gun with Orbafoam Cleaner.
If necessary, you can remove the fresh foam with the same Orbafoam Cleaner, used to clean the gun. In addition, we also have Orbafoam Cured Pu Foam Remover.